Is there a way to change the way RGB values are displayed in the material ppg?
They are displayed as 0.000-1.000 normalized values, but I would rather see them displayed from 0-255.
Is there something in the .spdl I can modify here?
Change how RGB values are displayed?
- AceMastermind
- Posts: 160
- Joined: 15 Jun 2009, 00:57
- Contact:
Re: Change how RGB values are displayed?
you can't.
but if you click the color chip (the rectangle that displays the color, at the left of the vertical R,G,B letters), you'll get the color popup, and in the there you can turn off "normalized" in the [>] menu. Then the color popup will show the colors as 0...255, but the sliders will always be normalized.
but if you click the color chip (the rectangle that displays the color, at the left of the vertical R,G,B letters), you'll get the color popup, and in the there you can turn off "normalized" in the [>] menu. Then the color popup will show the colors as 0...255, but the sliders will always be normalized.
- AceMastermind
- Posts: 160
- Joined: 15 Jun 2009, 00:57
- Contact:
Re: Change how RGB values are displayed?
Ah that's a shame, yeah I knew about the color box method, I was just hoping there was a way to avoid the extra steps, thanks.
Who is online
Users browsing this forum: No registered users and 34 guests