This is a fixed knob for an external door.
Main question is if i need to split the model ( and if so in what place i should split in two pieces) or i need some sort of temporary or fixed structure for the overhang in the knob base.
The thickness is 1 mm all over is this okay?
This will be for outside and it will be painted. What would be the best material for exterior ABS, other?
Anyone did 3D printing, need some advice
-
Bullit
- Moderator
- Posts: 2621
- Joined: 24 May 2012, 07:44
Anyone did 3D printing, need some advice
You do not have the required permissions to view the files attached to this post.