PPG Command
PPG Command
I've been looking on the Wiki page, how to create a custom PPG, it doesn't tell me what to begin with ?
- Daniel Brassard
- Posts: 878
- Joined: 18 Mar 2010, 23:38
- Location: St. Thomas, Ontario
- Contact:
Re: PPG Command
I will assume you read this section of the SDK
http://download.autodesk.com/global/doc ... us_ppg.htm
* Start small with say, a simple PPG that do one or two simple things.
* Look at the examples in the SDK to understand the PPG process.
* Use the Wizard to start the PPG with the bare bone code and expand from there.
Then ask question when you are stuck here!
Good Luck.
http://download.autodesk.com/global/doc ... us_ppg.htm
* Start small with say, a simple PPG that do one or two simple things.
* Look at the examples in the SDK to understand the PPG process.
* Use the Wizard to start the PPG with the bare bone code and expand from there.
Then ask question when you are stuck here!
Good Luck.
$ifndef "Softimage"
set "Softimage" "true"
$endif
set "Softimage" "true"
$endif
Who is online
Users browsing this forum: No registered users and 26 guests