Hi,
I've got a subscription to Digit*** T**** and there is some rigging training on how to setup a reverse footrig. I think that setup is to difficult. Is their a another easier way
-> not the Josh Enes way -> to do a reverse footrig. In short can someone tell me how to setup a very simple reverse footrig with not to much constraints?
(With small schematic drawing -> I hope I'm not asking to much. )
Another thing I haven't figured out is how to do an anatomic correct rolling of the lower arm bones -> for instance when you turn your hand on a table. Anatomically your os radius turn into
your os ulna. Your radius legg rolls over the ulna while your ulna stays straight.
Thanks in advance,
Is there a simplified Reverse footrig scheme
-
- Moderator
- Posts: 754
- Joined: 25 Nov 2009, 01:41
- Contact:
Re: Is there a simplified Reverse footrig scheme
If you have Softimage 2012 SAP I can send you a model of a leg rig for the foot setup.
- minilogoguy18
- Posts: 110
- Joined: 24 Dec 2012, 19:34
Re: Is there a simplified Reverse footrig scheme
I know this topic is a bit old but I was just like you, I had been taught the same way through the old DT DVD that I bought, that control is very easy to break and doesn't do everything.
I know you wanted something simple but a good reverse foot rig isn't simple but this one I found works great and I have not been able to break it.
Hope that helps anyone in the future.
I know you wanted something simple but a good reverse foot rig isn't simple but this one I found works great and I have not been able to break it.
Hope that helps anyone in the future.
-
- Posts: 91
- Joined: 19 Dec 2012, 18:16
Re: Is there a simplified Reverse footrig scheme
Thanks for the tutorial! I just wish there was sound.
Who is online
Users browsing this forum: No registered users and 29 guests