ICE extrude edge?

Discussions about SOFTIMAGEs© Interactive Creative Environment©
Post Reply
User avatar
Unaided
Posts: 62
Joined: 26 Feb 2014, 16:35

ICE extrude edge?

Post by Unaided » 09 Nov 2016, 16:25

As well know ICE was not full completed for work with topology (thanks to autodesk), I would like to know if there is possible doing a extrude/duplicate an edge.

User avatar
rray
Moderator
Posts: 1774
Joined: 26 Sep 2009, 15:51
Location: Bonn, Germany
Contact:

Re: ICE extrude edge?

Post by rray » 10 Nov 2016, 01:14

A simple way to extrude all boundary edges is to use the "extrude polygon island" compound with "get polygon index" plugged in.
softimage resources section updated Jan 5th 2024

User avatar
Unaided
Posts: 62
Joined: 26 Feb 2014, 16:35

Re: ICE extrude edge?

Post by Unaided » 10 Nov 2016, 07:11

I had not figure out that "extrude polygon island" could use to extrude edges. I have to try this.
Thank you so much rray!

Post Reply

Who is online

Users browsing this forum: No registered users and 23 guests